Peer - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – Routing Protocol
Related command: rip work.
Example
# Enable RIP on the interface with the network address 129.102.0.0.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] rip
[3Com-rip] network 129.102.0.0

2.1.10 peer

Syntax
peer ip-address
undo peer ip-address
View
RIP view
Parameter
ip-address: IP address of the interface on the peer router with which routing
information needs to be exchanged, in dotted decimal notation.
Description
Use the peer command to configure the destination address of the peer device with
which routing information should be exchanged in unicast mode.
Use the undo peer command to cancel a unicast address.
By default, RIP does not send packets to any address in unicast mode.
This command is used to for non-broadcast networks to which protocol packets
cannot be sent in broadcast mode. And you are not recommended to use this
command in normal situation.
Example
# Specify a unicast destination address of 202.38.165.1.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] rip
[3Com-rip] peer 202.38.165.1
Chapter 2 RIP Configuration Commands
2-10