Dot1X Re-Authenticate - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – 802.1x
Example
# Enable the quiet-period timer.
<3Com>system-view
System View: return to User View with Ctrl+Z.
[3Com] dot1x quiet-period

1.1.10 dot1x re-authenticate

Syntax
dot1x re-authenticate [ interface interface-list ]
undo dot1x re-authenticate [ interface interface-list ]
View
System view, Ethernet port view
Parameter
interface-list: List of Ethernet ports, expressed as interface-list = { interface-name [ to
interface-name ] } & < 1-10 >. The interface-name argument specifies the port index of
an Ethernet port and can be specified in this form: interface-name = { interface-type
interface-num }, where interface-type specifies the type of a port and interface-num
identifies the port number. "&<1-10>" means that up to 10 port indexes/port index lists
can be provided.
Description
Use the dot1x re-authenticate command to enable 802.1x re-authentication on the
specified port or on all Authenticator ports of the switch.
Use the undo dot1x re-authenticate command to disable 802.1x re-authentication on
the specified port or on all Authenticator ports of the switch.
By default, 802.1x re-authentication is disabled on all ports.
When you use this command in system view, if you do not specify a port, this command
will enable 802.1x re-authentication on all ports; if you provide a value for the
interface-list argument, this command will enable 802.1x on the specified port.
When you use this command is Ethernet port view, the interface-list argument is not
available and 8021.x re-authentication is enabled on the current port only.
802.1x must be enabled globally and on the current port before 802.1x
re-authentication can be configured on the port.
Example
# Enable 802.1x re-authentication on the port Ethernet 3/0/1.
<3Com>system-view
Chapter 1 802.1x Configuration Commands
1-13