Send And Receive Port; Displaying Mvr Configuration; Igmp Filtering And Throttling - Siemens S223 User Manual

UMN:CLI
9.2.7.4
9.2.7.5
9.2.8
300
To delete the statically configured MVR group address, use the following command.
Command
no mvr vlan VLAN helper

Send and Receive Port

Statically configure a VLAN interface to receive multicast traffic sent to the multicast
VLAN and the IP multicast address. An interface statically configured as a member of a
group remains a member of the group until statically removed.
Command
mvr port PORTS type { receiver |
source }
•
Source
This configures uplink ports that receive and send multicast data as source ports.
Subscribers cannot be directly connected to source ports. All source ports on a switch
belong to the single multicast VLAN.
•
Receiver
This configures a port as a receiver port if it is a subscriber port and should only re-
ceive multicast data. It does not receive data unless it becomes a member of the
multicast group, either statically or by using IGMP leave and join messages. Receiver
ports cannot belong to the multicast VLAN.
To delete the statically configured MVR port, use the following command.
Command
no mvr port PORTS

Displaying MVR Configuration

To display an MVR configuration, use the following command.
Command
show mvr
show mvr port
show mvr vlan VLANS

IGMP Filtering and Throttling

With the IGMP filtering feature, you can filter multicast joins on a per-port basis by config-
uring IP multicast profiles and associating them with individual switch ports. An IGMP pro-
file can contain one or more multicast groups and specifies whether access to the group
is permitted or denied. If an IGMP profile denying access to a multicast group is applied
to a switch port, the IGMP join report requesting the stream of IP multicast traffic is
SURPASS hiD 6615 S223/S323 R1.5
Mode
Deletes a MVR group address.
Global
IP ADDRESS: specific IP address
Mode
Configures MVR port.
Global
PORTS: port number
Mode
Global Deletes a MVR port.
Mode
Enable
Shows a configuration.
Global
User Manual
Description
Description
Description
Description
A50010-Y3-C150-2-7619