Table of Contents
Advertisement
Chapter 5
Setup and Configuration
Section 5.14.3
Adding DHCP Client Ports
To add a client port for the DHCP relay agent, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the client port by typing:
switch dhcp-relay-agent
Where:
• slot is the name of the module location.
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module.
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.14.4
Deleting a DHCP Client Port
To delete a client port for the DHCP relay agent, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the client port by typing:
no switch dhcp-relay-agent
Where:
• slot is the name of the module location.
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module.
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.15
Managing the DHCP Server
Dynamic Host Configuration Protocol (DHCP) is a method for centrally and consistently managing IP addresses
and settings for clients, offering a variety of assignment methods. IP addresses can be assigned based on the
Ethernet MAC address of a client either sequentially or by using port identification provided by a DHCP relay
agent device.
The information that is assigned to addresses in DHCP is organized to deal with clients at the interface, subnet,
pool, shared network, host-group and host levels.
The following sections describe how to configure and manage the DHCP server:
•
Section 5.15.1, "Configuring the DHCP Server"
•
Section 5.15.2, "Enabling/Disabling the DHCP Server"
•
Section 5.15.3, "Enabling/Disabling the DHCP Relay Support"
•
Section 5.15.4, "Viewing a List of Active Leases"
•
Section 5.15.5, "Managing DHCP Listen Interfaces"
236
dhcp-client-ports slot port
dhcp-client-ports slot port
RUGGEDCOM ROX II
CLI User Guide
Adding DHCP Client Ports
Advertisement
Table of Contents
Troubleshooting
