Device Range That Can Be Set; Precautions - Mitsubishi Electric GT1685 Connection Manual

17.5 Device Range that Can Be Set

For details on the device range that can be used on the
GOT, refer to the following.
2.3 MELSEC-QnU/DC, Q17nD/M/NC/DR,
CRnD-700

17.6 Precautions


When setting IP address
Do not use "0" and "255" at the end of an IP address.
(Numbers of *.*.*.0 and *.*.*.255 are used by the
system)
The GOT may not monitor the controller correctly with
the above numbers.
Consult with the administrator of the network before
setting an IP address to the GOT and controller.

When connecting to the multiple network
equipment (including GOT) in a segment
By increasing the network load, the transmission speed
between the GOT and PLC may be reduced.
The following actions may improve the communication
performance.
• Using a switching hub
• More high speed by 100BASE-TX (100Mbps)
• Reduction of the monitoring points on GOT
17 - 8
17. ROBOT CONTROLLER CONNECTION
17.5 Device Range that Can Be Set