Cc-Link Ie Controller Network Connection (Network System); System - Mitsubishi Electric GT1685 Connection Manual

4.6 CC-Link IE Controller Network Connection (Network

System)

This section explains the CC-Link IE Controller Network connection (network system) that connects the GOT to the CC-
Link IE controller network.
The following shows an example of connecting the GOT set as a normal station to the CC-Link IE Controller Network.
Network No. 1, Station No. 1
(Control station)
Monitor target
Control
system
(System A)
(1) Connection method
Connect the GOT to the CC-Link IE Controller Network.
For details, refer to the following.
11. CC-Link IE CONTROLLER NETWORK CONNECTION
(2) GT Designer3 setting
Set GT Designer3 as described below.
Setting item
Controller Type
Device setting (Network setting)
Q Redundant Setting
*1 GT14 is not compatible with MELSEC-QS.
To specify the station number which was set in the Q redundant setting in the device setting, set the station
number as the other station.
(3) Monitoring target change when system switching occurs in a redundant system
When system switching occurs, the network module station No.2 changes from a normal station to the sub
control station, and the system with the module takes over the control of the CC-Link IE Controller Network as
the control system.
Since the GOT monitors the control system, the monitoring target is automatically changed to the network
module station No. 2.
Network No. 1, Station No. 3 (Normal station)
GOT
CC-Link IE Controller Network
MELSECNET/H remote I/O network
MELSEC-QnA/Q/QS, MELDAS C6*
NW No.: Network No. of CC-Link IE Controller Network
Other
Station No.: Station number of the control system
4.9 Q Redundant Setting
4. HOW TO MONITOR REDUNTANT SYSTEM

4.6 CC-Link IE Controller Network Connection (Network System)

Network No. 1, Station No. 2
(Normal station)
Settings
1
2
3
Standby
system
(System B)
4
5
Model
6
7
8
4 - 23