Mitsubishi Electric GT1685 Connection Manual page 641

(6) Ethernet(MELSEC), Q17nNC, CRnD-700
(a) GT16, GT14
Item Description
Set the network No. of the GOT.
GOT NET No.
(Default: 1)
GOT PLC
Set the station No. of the GOT.
*2
(Default: 1)
No.
GOT
Set the IP address of the GOT.
*1
(Default: 192.168.3.18)
IP Address
Set the subnet mask for the sub
network.(Only for connection via
Subnet
router)
*1
If the sub network is not used, the
Mask
default value is set.
(Default: 255.255.255.0)
Set the router address of the
default gateway where the GOT is
Default
connected.(Only for connection via
Gateway
router)
*1
(Default: 0.0.0.0)
Ethernet
Set the GOT port No. for Ethernet
Download Port
download.
*1
(Default: 5014)
No.
Set the GOT port No. for the
GOT
connection with the Ethernet
Communication
module.
Port No.
(Default: 5001)
Set the number of retries to be
performed when a communication
timeout occurs.
Retry When receiving no response after
retries, the communication times
out.
(Default: 3times)
Specify the time period from the
GOT startup until GOT starts the
Startup Time
communication with the PLC CPU.
(Default: 3sec)
Set the time period for a
Timeout Time communication to time out.
(Default: 3sec)
Set the delay time for reducing the
load of the network/destination
Delay Time
PLC.
(Default: 0ms)
Range
1 to 239
1 to 64
0.0.0.0 to
255.255.255.255
0.0.0.0 to
255.255.255.255
0.0.0.0 to
255.255.255.255
1024 to 5010,
5014 to 65534
(Except for 5011,
5012, 5013 and
49153)
1024 to 5010 to
5014 to 65534
(Except for 5011,
5012, 5013 and
49153)
0 to 5times
3 to 255sec
3 to 90sec
0 to 10000
( 10ms)
*1 Click the [Setting] button and perform the setting in the [GOT
IP Address Setting]
screen.
*2 Each of [GOT PLC No.] set in the communication detail
setting and [PLC No.] set in the Ethernet setting must be set
to different station numbers.
18.4.3 Ethernet setting
18. CNC CONNECTION
18.4 GOT Side Settings
17
18
19
20
21
22
23
18 - 11