Got Side Settings; Setting Communication Interface (Communication Settings); Communication Detail Settings - Mitsubishi Electric GT1685 Connection Manual

12.3 GOT side settings

12.3.1 Setting communication
interface (Communication
settings)
Set the channel of connecting equipment.
2.
1.
Select [Common] [Controller Setting] from the
menu.
2.
The Controller Setting window is displayed. Select the
channel to be used from the list menu.
3.
Set the following items.
• Manufacturer: MITSUBISHI ELECTRIC
• Controller Type: Set according to the Controller
Type to be connected.
• I/F: Interface to be used
• Driver: CC-Link IE Field Network
4.
The detailed setting is displayed after Manufacturer,
Controller Type, I/F, and Driver are set.
Make the settings according to the usage
environment.

12.3.2 Communication detail settings

Click the [OK] button when settings are completed.
POINT POINT POINT
The settings of connecting equipment can be
confirmed in [I/F Communication Setting].
For details, refer to the following.
1.1.2 I/F communication setting
12.3.2 Communication detail settings
Make the settings according to the usage environment.
3.
4.
Item
Network
*4
Type
Click!
Network No.
Station No.
Mode Setting
Refresh
Interval
Input for Error
Station
Retry
Timeout
Time
Delay Time
Monitor
Speed
12. CC-Link IE FIELD NETWORK CONNECTION
Description
Set the network Type
Set the network No. of the GOT.
(Default: 1)
Set the station No. of the GOT.
(Default: 1)
Set the operation mode of the GOT.
(Default:
Online (auto. reconnection))
Set the number of refreshes to
secure the send/receive data in
station units during communication.
(Default: 25ms)
Set the hold/clear of input from the
station where the data link is faulty
due to some reason such as turning
the power OFF.
(Default: Clear)
Set the number of retries to be
performed when a communication
timeout occurs.
When receiving no response after
retries, the communication times
out.
(Default: 3times)
Set the time period for a
communication to time out.
(Default: 3sec)
Set the delay time for reducing the
load of the network/destination PLC.
(Default: 0ms)
Set the monitor speed for the CC-
Link IE field network.
This setting is not valid in all
systems.
(Default: High)
(Continued to next page)
12.3 GOT side settings
9
10
11
12
Range
• CC IE Field
1 to 239
1 to 120
• Online
13
• Offline
*1
• H/W test
• Self-loopback
*1
test
1 to 1000ms
14
Clear/Hold
0 to 5times
15
3 to 90sec
0 to 300ms
16
*2 *3
High /Normal/Low
12 - 9