Accessing By Nc Configurator - Mitsubishi Electric GT1685 Connection Manual

6.
On the [PLC side I/F setting of PLC module], mark the
[via GOT (Ethernet) transparent mode] checkbox and
click [Set].
7.
Set [QJ71E71] for [Type].
8.
Specify the number assigned to the Ethernet module
for [Network No.], [Station No.] and [IP Address] in
"Module side".
9.
Specify the number assigned to the GOT for [Network
No.], [Station No.] and [IP Address] in "GOT side".
10.
As necessary, select a CPU that is targeted in [CPU].

23.6.15 Accessing by NC Configurator

The following shows the procedure to set the FA
transparent function of NC Configurator.
1.
Click [File] [Open].
2.
The [Open] is displayed.
3.
Select [NC] on the upper left of the screen, and set
the following:
NC series : C70 M or C70 L
Connect pattern : Set the pattern according to the
connect pattern.
IP address : Set as necessary.
4.
By clicking [Open], data is read from CNC and
displayed.
23. FA TRANSPARENT FUNCTION
23.6 Personal Computer Side Setting
17
18
19
20
21
22
23
23 - 77