Set the [PLC side] in [Connection setup].
PLC type: Q series PLC type
Multi PLC specification: None/No.1 to 4
Direct CPU connection, mark the [via GOT
transparent mode] checkbox.
Direct CPU connection
Type: Direct coupled
Computer link connection
(For bus connection only)
Set the [Module connecting I/O address] in
Specify the actual IP address of the module.
The screen returns to the [Connection setup]. Click
the [Connection Test] to check if GX Developer has
been connected to the QD75***(QnCPU).
23 - 68
23. FA TRANSPARENT FUNCTION
23.6 Personal Computer Side Setting
23.6.7 Accessing by the MT
This section explains the procedure to set the FA
transparent function of MT Developer with an example of
connecting to motion controller CPU (Q series).
Check-mark either of the following in [Serial port].
When connecting the GOT and PC with serial
Mark the [RS-232C] checkbox.
When connecting the GOT and PC with USB
Mark the [USB] checkbox.
[Communication Setting] in