Mitsubishi Electric GT1685 Connection Manual page 432

(b) Network Configuration Settings
Item
Rx/RY Station
Rx/RY, setting No.1
RWw/RWr
*1
Setting (1) RWw/RWr Station
setting No.1
Reserved/Error Invalid Station
: Necessary
*1 Be sure to set it to perform the cyclic transmission.
POINT POINT POINT
(1) When changing the unit parameter
After writing unit parameters to the PLC CPU, turn
the PLC CPU OFF then back ON again, or reset
the PLC CPU.
(2) GOT station type
Set the GOT as an intelligent device station.
12 - 12
12. CC-Link IE FIELD NETWORK CONNECTION
12.4 PLC Side Setting
Setting necessity
Set value at GOT
connection
Start 0000
H
End 00FF
H
Start 0000
H
End 00FF
H
No setting
: As necessary : Not necessary
(c) Routing setting
Up to 238 [Target Station Network No.]s can be set.
However, the same target station network number
cannot be set twice or more (multiple times).
Therefore, the one that can access to other station
from the request source host GOT is 238 kinds of
[Target Station Network No.]s.
Item
Target Station Network No.
Relay Station Network No.
Relay Station No.
POINT POINT POINT
Routing parameter setting of request source
Routing parameter setting is also necessary for the
request source GOT.
For the setting, refer to the following.
11.3.3 Routing parameter setting
Range
1 to 239
1 to 239
1 to 120