Mitsubishi Electric GT1685 Connection Manual page 472

*1
Item
Sta.
No.1
Reserve/invalid
station select
Sta.
No.2
Intelligent buffer select
(word)
: Necessary
*1 When the [Mode] of the CC-Link module is set at [Remote
net - (Ver. 2 mode)], [Remote station points] can be set.
[Remote station points] is a setting for the remote I/O station.
The default value (32 points) must be used on the GOT.
*2 Set the same setting as that of the GOT.
POINT POINT POINT
When changing the network parameter
After writing the network parameter to the C Controller
module (Q Series), either turn the C Controller module
(Q Series) OFF and then ON or reset it

[Controller Setting] of GT Designer3
(1) Communication Settings of station No.1 (GOT)
(a) When MODEL GT15-J61BT13 CC-Link
communication unit is used
Item
Station No.
Transmission Rate
Mode
Expanded Cyclic
Number of stations occupied
Input for Error Station
Retry
Timeout Time
Delay Time
(b) When MODEL GT15-75J61BT13-Z CC-Link
communication unit is used
Item
Retry
Timeout Time
13 - 32
13. CC-Link CONNECTION (INTELLIGENT DEVICE STATION)
13.4 PLC Side Setting
Setting
necessity at
Set value
GOT
connection
No setting
No setting
(Use default value)
: As necessary : Not necessary
Set value
1: Station No.1
0: Online 156kbps
Ver.1: Remote net (Ver.1 mode)
Single (Use default value)
1 Station
0: Clear
3times (Use default value)
3sec (Use default value)
0ms (Use default value)
Set value (Use default value)
3times
3sec
(2) Communication Settings of station No.2 (GOT)
Item
Station No.
Transmission Rate
Mode
Expanded Cyclic
Number of stations occupied
Input for Error Station
Retry
Timeout Time
Delay Time

Setting of the CC-Link communication unit
(Only when MODEL GT15-75J61BT13-Z
CC-Link communication unit is used)
Item
Mode setting switch
Station number setting switch
Transmission baudrate setting switch
SW1 (Input data status of the
Condition
data link error station)
setting
SW2 (Number of occupied
switches
stations)
POINT POINT POINT
Setting of the CC-Link communication unit
For the setting method of the CC-Link communication
unit, refer to the following.
13.3.3 Switch setting (Only when MODEL
GT15-75J61BT13-Z CC-Link communication
unit is used)
Set value (Use default value)
2: Station No.2
0: Online 156kbps
Ver.2: Remote net (Ver.2 mode)
Single
1 Station
0: Clear
3times (Use default value)
3sec (Use default value)
0ms (Use default value)
Set value
0: Online (fixed)
1: Station No.1
0: 156kbps
OFF: Cleared
OFF: 1 station