Mitsubishi Electric GT1685 Connection Manual page 336

Got1000 series
Table of Contents

Advertisement

(2) Operational settings
Item
Communication
(Use default value.)
*1
date code
IP address
192.168.0.19
*1
Initial timing
Send frame setting
(Use default value.)
TCP Existence
confirmation setting
:Required
Because the port No. 5551 is fixed, the GOT oper-
*1
ates as follows, regardless of the setting for the item.
• Communication date code : [Binary code]
• Initial timing : [Always wait for OPEN]
(Communications are enabled while the programmable
controller CPU stops.)
*2
The default value of IP address is 192.168.1.254. Set the IP
address corresponding to the system configuration.
POINT
POINT
POINT
When changing Ethernet parameter
After writing the Ethernet parameter to the
programmable controller CPU, turn off and then on, or
reset the programmable controller CPU.
8 - 50
8. ETHERNET CONNECTION
8.4 PLC Side Setting
Setting
Setting
(with GOT connected)
:Set if necessary
:Not required
(3) Open settings
Item
Protocol
Open system
MELSOFT connection
Fixed buffer
Fixed buffer communication
procedure
Pairing open
Existence confirmation
(Use default value.)
Host station Port No.
(DEC.)
Transmission target device
IP address
Transmission target device
Port No. (DEC.)
:Required
POINT
POINT
POINT
When connecting to multiple GOTs and peripheral
devices
The number of protocols equivalent to that of the GOTs
and devices must be set.
Setting
Setting
(with GOT connected)
TCP
:Set if necessary
:Not required

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents