Mitsubishi Electric GT1685 Connection Manual page 326

(d) System settings
Item
Points occupied by empty
slot
Remote reset
Output mode at STOP to
RUN
Intelligent function module
settings
Initial settings of intelligent
function module
WDT (Watchdog timer)
setting
Error check
Operation mode at the
time of error
Module synchronization
Built-in Ethernet port open
settings
Event history registration
settings
: Necessary
8 - 40
8. ETHERNET CONNECTION
8.4 PLC Side Setting
Setting
necessity at
Set value
GOT
connection
(Use default value)
Mark the checkbox
(Use default value)
: As necessary : Not necessary
(2) Q24DHCCPU-V/VG
Use SW4PVC-CCPU-E for the C Controller (Q Series)
setting utility.
(a) Connection settings
Item
*1
IP Address
Subnet Mask
Default Gateway
: Necessary
*1 If the IP address of the C Controller module (Q Series) has
been changed, input the changed IP address.

[Controller Setting] and [Ethernet] of GT
Designer3
POINT POINT POINT
(1) [Controller Setting] and [Ethernet] of GT
Designer3
For [Controller Setting] and [Ethernet] of GT
Designer3, refer to the following.
8.3.1 Setting communication interface
(Communication settings)
(2) Ethernet setting
When connecting C Controller module (Q Series)
to a GOT, the setting items for the network No. and
station No. do not exist at the PLC side. However,
these virtual values must be set on the GOT side.
Therefore, set the network No. and station No.
Set the network No. that is not existed on the
network system and any station No..
Setting
necessity at
Set value
GOT
connection
192.168.3.39
(Default)
255.255.255.0
(Default)
-
: As necessary : Not necessary