Mitsubishi Electric GT1685 Connection Manual page 487


[Controller Setting] of GT Designer3
(1) When MODEL GT15-J61BT13 CC-Link
communication unit is used
Item
Station No.
Transmission Rate
Mode
Expanded Cyclic
Number of stations occupied
Input for Error Station
Retry
Timeout Time
Delay Time
(2) When MODEL GT15-75J61BT13-Z CC-Link
communication unit is used
Item
Retry
Timeout Time
POINT POINT POINT
[Controller Setting] of GT Designer3
For the setting method of [Controller Setting] of GT
Designer3, refer to the following.
13.3.1 Setting communication interface
(Communication settings)

Setting of the CC-Link communication unit
(Only when MODEL GT15-75J61BT13-Z
CC-Link communication unit is used)
Item
Mode setting switch
Station number setting switch
Transmission baudrate setting switch
SW1 (Input data status of the
Conditio
data link error station)
n setting
SW2 (Number of occupied
switches
stations)
POINT POINT POINT
Setting of the CC-Link communication unit
For the setting method of the CC-Link communication
unit, refer to the following.
13.3.3 Switch setting (Only when MODEL
GT15-75J61BT13-Z CC-Link communication
unit is used)
Set value
1: Station No.1
0: Online 156kbps
Ver.1: Remote net (Ver.1 mode)
Single (Use default value)
1 Station
0: Clear
3times (Use default value)
3sec (Use default value)
0ms (Use default value)
Set value (Use default value)
3times
3sec
Set value
0: Online (fixed)
1: Station No.1
0: 156kbps
OFF: Cleared
OFF: 1 station
13. CC-Link CONNECTION (INTELLIGENT DEVICE STATION)
13.4 PLC Side Setting
9
10
11
12
13
14
15
16
13 - 47