Mitsubishi Electric GT1685 Connection Manual page 415

 Parameter setting (when connecting to C
Controller module (Q Series))
Use SW3PVC-CCPU-E Ver.3.05F or later for the CC IE
Control utility.
(1) Connection settings between personal computer
and C controller module (Q Series)
Item
*1
192.168.3.3 (Default)
Target module
Write authority Mark the checkbox
*2
User name
*2
Password
Detailed settings
: Necessary
*1 If the IP address of the C Controller module (Q Series) has
been changed, input the changed IP address or host name.
*2 If the account of the C Controller module (Q Series) has
been changed, input the changed user name and password.
Setting
necessity at
Set value
GOT
connection
target
password
-
: As necessary : Not necessary
11. CC-Link IE CONTROLLER NETWORK CONNECTION
(2) CC IE Control Utility's [Parameter Settings]
(a) Parameter settings
Item
Number of modules
Link device refresh cycle (Use default value)
Routing parameter
Target module
Start I/O No.
Channel No.
Network type
(Control station)
*1
Mode
*2
Network No.
Group No.
Station No.
Refresh parameters (Use default value)
Network range
assignment
: Necessary
*1 Set the same mode setting as that of the GOT.
*2 Specify the same network No. as that of the GOT.
11.4 PLC Side Setting
Setting
necessity at
Set value
GOT
connection
1
Refer to (c)
1
0000
H
151
CC IE Control
Online
1
0
1
Refer to (b)
: As necessary : Not necessary
11 - 21
9
10
11
12
13
14
15
16