Mitsubishi Electric GT1685 Connection Manual page 249

Item Description
Select the communication format.
*3
Format
(Default: 1)
Set the monitor speed of the GOT.
Monitor Speed
This setting is not valid in all systems.
(GT16 only)
(Default: Normal)
*1 This is effective when collecting a large data on other than
the monitor screen (logging, recipe function, etc.). However,
when connecting to Q00J/Q00/Q01CPU, the sequence scan
time may be influenced. If you want to avoid the influence on
the sequence scan time, do not set "High".
(High performance is hardly affected)
*2 Set this item if you want to avoid the influence on the
sequence scan time further than the "Normal" setting when
connecting to Q00J/Q00/Q01CPU. However, the monitor
speed may be reduced.
*3 The format setting differs depending on the controller.
L6ADP-R4 adapter
Other than L6ADP-R4 adapter: [1]
(2) MELSEC-FX
(a) For GT16, GT15, GT14, GT12, GT11
Description
Item
Set this item when change the
transmission speed used for
communication with the connected
equipment.
Transmission (Default: 115200bps)
Speed When the setting exceeds the limit of the
connected equipment, communication is
performed at the fastest transmission
speed supported by the connected
equipment.
Set the number of retries to be
performed when a communication
timeout occurs. When receiving no
Retry
response after retries, the
communication times out.
(Default: 0time)
Set the time period for a communication
Timeout Time to time out.
(Default: 3sec)
Set this item to adjust the transmission
timing of the communication request
Delay Time
from the GOT.
(Default: 0ms)
Range
1, 2
*1
High
Normal
*2
Low
: [2]
Range
9600bps,
19200bps,
38400bps,
57600bps,
115200bps
0 to 5times
3 to 30sec
0 to 300 (ms)
(b) For GT10
Description
Item
Set this item when change the
transmission speed used for
communication with the connected
equipment.
Transmission (Default: 115200bps)
Speed When the setting exceeds the limit of the
connected equipment, communication is
performed at the fastest transmission
speed supported by the connected
equipment.
(3) Serial (MELSEC) (GT10)
Item Description
Set this item when change the transmission
speed used for communication with the
connected equipment.
(Default: 115200bps)
Transmission
When the setting exceeds the limit of the
Speed
connected equipment, communication is
performed at the fastest transmission
speed supported by the connected
equipment.
6. DIRECT CONNECTION TO CPU
6.4 GOT Side Settings
1
2
Range
3
9600bps,
19200bps,
38400bps,
57600bps,
115200bps
4
5
6
Range
9600bps,
19200bps,
38400bps,
57600bps,
115200bps
7
8
6 - 31