Mitsubishi Electric GT1685 Connection Manual page 467

(b) Station information setting
*1
Item
Ver.2 intelligent device
Station type
*2
Expanded cyclic setting
*2
Exclusive station 1
Exclusive station count
Remote station points
Reserve/invalid station select
Intelligent buffer select (word) (Use default value)
: Necessary
*1 When the [Mode] of the CC-Link module is set at [Remote
net - (Ver. 2 mode)], [Remote station points] can be set.
[Remote station points] is a setting for the remote I/O station.
The default value (32 points) must be used on the GOT.
*2 Set the same setting as that of the GOT.
POINT POINT POINT
When changing the network parameter
After writing the network parameter to the PLC CPU,
operate the PLC CPU ether turning OFF and then ON
or resetting.
Setting
necessity at
Set value
GOT
connection
station (fixed)
Single
32 points (fixed)
No setting
: As necessary : Not necessary
13. CC-Link CONNECTION (INTELLIGENT DEVICE STATION)

Parameter setting (when connecting to C
Controller module (Q Series))
Use SW3PVC-CCPU-E Ver.3.05F or later for the CC-
Link utility.
(1) Connection settings
Item
*1
192.168.3.3 (Default)
Target module
Write authority Mark the checkbox
*2
User name
*2
Password
Detailed settings
: Necessary
*1 If the IP address of the C Controller module (Q Series) has
been changed, input the changed IP address or host name.
*2 If the account of the C Controller module (Q Series) has
been changed, input the changed user name and password.
13.4 PLC Side Setting
Setting
Set value necessity at
GOT connection
target
password
-
: As necessary : Not necessary
13 - 27
9
10
11
12
13
14
15
16