Mitsubishi Electric GT1685 Connection Manual page 434


Unit parameter settings of System
configuration (Network Type: CC IE Field)
(1) [Module parameter] of CW Configurator
(a) Module parameter
Item
Station type
*1
Network No.
Station No.
Parameter setting
Channel No.
Network Configuration
Settings
: Necessary
*1 Specify the same network No. as that of the GOT.
12 - 14
12. CC-Link IE FIELD NETWORK CONNECTION
12.4 PLC Side Setting
Setting
Set value necessity at
GOT connection
Master station (fixed)
1
0 (fixed)
Parameter
(Use default value)
Refer to (b)
: As necessary : Not necessary
(b) Network Configuration Settings
Item
Rx/RY Station
Rx/RY, setting No.1
RWw/RWr
*1
Setting (1) RWw/RWr Station
setting No.1
Reserved/Error Invalid Station
: Necessary
*1 Be sure to set it to perform the cyclic transmission.
POINT POINT POINT
(1) When changing the unit parameter
After writing unit parameters to the PLC CPU, turn
the PLC CPU OFF then back ON again, or reset
the PLC CPU.
(2) GOT station type
Set the GOT as an intelligent device station.
Setting necessity
Set value at GOT
connection
Start 0000
H
End 00FF
H
Start 0000
H
End 00FF
H
No setting
: As necessary : Not necessary