Accessing By The Mt Works2 - Mitsubishi Electric GT1685 Connection Manual

4.
Check-mark either of the following in [PLC side I/F
setting of PLC module].
Bus connection
[via GOT(Bus) transparent mode]
Direct CPU connection
[via GOT(direct coupled) transparent mode]
5.
As necessary, select a CPU that is targeted by using
the transparent function in [CPU].
6.
Click [Connection Test].
7.
Confirm that the personal computer is connected to
the motion controller CPU (Q series).

23.6.8 Accessing by the MT Works2

This section explains the procedure to set the FA
transparent function of MT Works2 with an example of
connecting to motion controller CPU (Q series).

When connecting the GOT and personal
computer with serial or USB
(1) Connecting the GOT and PLC in bus connection or
direct CPU connection
1.
Click [Transfer setup]
2.
The [Transfer setup] is displayed.
3.
Set the [Transfer setup]:
PC side I/F : Serial USB
CPU side I/F : GOT
Other Station Setting : No specification
4.
Double-click [Serial] of the PLC side I/F to display [PC
side I/F Serial setting].
5.
Check-mark either of the following in [PC side I/F
Serial setting].
When connecting the GOT and PC with serial
Mark the [RS-232C] checkbox.
When connecting the GOT and PC with USB
Mark the [USB] checkbox.
23. FA TRANSPARENT FUNCTION
23.6 Personal Computer Side Setting
[Online].
23 - 69
17
18
19
20
21
22
23