Connection To C Controller Module (Melsec Iq-R Series) - Mitsubishi Electric GT1685 Connection Manual

13.4.4 Connection to C Controller
module (MELSEC iQ-R
Series)
This section describes the settings of the GOT and C
Controller module (MELSEC iQ-R Series) in the following
case of system configuration.
Use CW Configurator for the C Controller module
(MELSEC iQ-R Series) communication settings.
POINT POINT POINT
CC-Link module (MELSEC iQ-R Series)
For details of the CC-Link module (MELSEC iQ-R
Series), refer to the following manual.
Manuals of MELSEC iQ-R Series

System configuration
■ [Controller Setting] of GT Designer3
<GOT (Ver.1 compatible)>
(Use default value for settings other than the following.)
*1
<CC-Link module>
(Use default value for settings other than the following.)
Type : Master station
Station No. : Station No. 0
Mode : Remote net (Ver.2 mode)
All connect count : 2
Transmission speed : 156kbps
■ Module parameter setting of CW Configurator
*1 The CC-Link module is mounted on the base unit slot 0.
The Start I/O No. of the CC-Link module is set to "0".
13 - 20
13. CC-Link CONNECTION (INTELLIGENT DEVICE STATION)
13.4 PLC Side Setting
Station type : Intelligent device
station
Station No. : Station No. 1
Number of stations
: Exclusive station 1
occupied
Transmission speed : 156kbps
<GOT (Ver.2 compatible)>
(Use default value for settings other
than the following.)
Station type : Intelligent device
station
Station No. : Station No. 2
Expanded cyclic setting : Single
Number of stations
: Exclusive station
occupied
Transmission speed : 156kbps

Module parameter setting of CW
Configurator
(1) [Module parameter] of CW Configurator
(a) Module parameter
Item
Station type
Mode
Station No.
*1
Transmission speed
Channel No.
: Necessary
*1 Adjust the settings with GOT settings.
(b) Link refresh setting
Item
Remote input (RX) refresh
device
Remote output (RY) refresh
device
Remote register (RWr)
refresh device
: Necessary
Setting
necessity at
Set value
GOT
connection
Master station
Remote net (Ver.2
mode)
0 (fixed)
156kbps
(Use default value)
: As necessary : Not necessary
Setting
necessity at
Set value
GOT
connection
Set as necessary.
: As necessary : Not necessary