Connecting To Ethernet Module (Melsec Iq-R Series) - Mitsubishi Electric GT1685 Connection Manual


Checking communication state of Built-in
Ethernet port CPU
(1) When using the Command Prompt of Windows
Execute a Ping command at the Command Prompt of

Windows .
(a) When normal communication
C:\>Ping 192.168.0.1
Reply from 192.168.0.1: bytes=32 time
<10ms TTL=32
(b) When abnormal communication
C:\>Ping 192.168.0.1
Request timed out.
(2) When abnormal communication
At abnormal communication, check the following and
execute the Ping command again.
• Cable connecting condition
• Confirmation of switch and network parameter setting
• Operation state of PLC CPU (faulty or not)
• The IP address of Built-in Ethernet port CPU specified
in the ping command
8 - 26
8. ETHERNET CONNECTION
8.4 PLC Side Setting
POINT POINT POINT
Ethernet diagnostics of GX Works3

.
Ethernet diagnostics of GX Works3 is available to a
Ping test from the PLC.
For details of Ethernet diagnostics of GX Works3, refer
to the following manual.
Manuals of MELSEC iQ-R Series
8.4.3
This section describes the settings of the GOT and
Ethernet module (MELSEC iQ-R Series) in the following
case of the system configuration.
POINT POINT POINT
Ethernet module (MELSEC iQ-R Series)
For details of the Ethernet module (MELSEC iQ-R
Series), refer to the following manual.
Manuals of MELSEC iQ-R Series

System configuration
*1 The Ethernet module is mounted on the base unit slot 0.
The Start XY No. of the Ethernet module is set to "0".
Connecting to Ethernet
module (MELSEC iQ-R
Series)
■ [Controller Setting] and [Ethernet] of GT
Designer3
<GOT>
(The settings other than the
following are set to the default)
Network No.
PLC No.
IP address
Port No.
Communication
format
*1
<Ethernet module>
(The settings other than the
following are set to the default)
Network No. : 1
PLC No. : 2
IP address : 192.168.3.19
Port No. : 5001
Communication : UDP (fixed)
format
■ [Module parameter] of GX Works3
: 1
: 1
: 192.168.3.18
: 5001
: UDP (fixed)