Mitsubishi Electric GT1685 Connection Manual page 113

Got1000 series

Table of Contents

(2) When connecting to QCPU (Q mode)/QnACPU/AnUCPU

• The GOT can monitor the control station and all the normal stations on the

• The GOT can monitor the control station and all the normal

stations on other networks.

(For monitoring stations on other networks, be sure to set the

routing parameter)

When the Universal model QCPU is used as a relay station, the

GOT can monitor stations with the station No.65 or later in the CC-

Link IE controller network.

• When connected to a relay station and the data link system is included,

the master station and local stations can be monitored.

• When connected to a relay station, it is not necessary to designate the

data link parameter [Effective unit number for accessing other stations]

for the PLC CPU of the connected station. (Even if designated, the

parameter is ignored)

• Devices of other stations (other than devices B and W that are allocated by the network parameter) may not

allow monitoring depending on their PLC CPU.

■ Monitor accessible range of other stations and setting method of monitor devices (Examples 1

The control station and normal station correspond to the master station and local station in the CC-Link IE field network

respectively.

(3) When connecting to AnACPU/AnNCPU

• The GOT can monitor the control station on the network.

When the PLC CPU on the control station is the QCPU (Q mode) or

QnACPU, the GOT cannot monitor devices other than B and W assigned

for the network parameter.

• The GOT cannot monitor normal stations on the network.

• The GOT cannot monitor any stations on the other networks.

3. ACCESS RANGE FOR MONITORING

3.1 Access Range for Monitoring Stations on Network Systems

Show Quick Links

Chapters

Table of Contents