Table of Contents
Advertisement
F
C
S
LOW
OMMANDS
SFLOW ENABLE
sflow enable
Overview
This command enables sFlow® globally on the switch.
The no variant of this command disables sFlow globally on the switch.
Note that enabling sFlow does not automatically set its operational status to
active. To activate sFlow the following conditions need to be met:
•
•
•
•
sflow enable
Syntax
no sflow enable
Default
sFlow is disabled globally on the switch.
Mode
Global Configuration
Example
To enable sFlow operation, use the command:
awplus#
awplus(config)#
Related
show running-config sflow
Commands
show sflow
C613-50103-01 REV A
sFlow is enabled.
The sFlow agent address is set.
The sFlow collector address is set to a valid (non zero) IPv4 or IPv6 address.
Polling or sampling is enabled on the ports to be sampled or polled.
configure terminal
sflow enable
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
2513
Advertisement
Table of Contents
