Table of Contents
Advertisement
F
C
S
LOW
OMMANDS
SHOW SFLOW
show sflow
Overview
This command displays non-port-specific sFlow agent configuration and
operational status.
show sflow
Syntax
Mode
Privileged Exec
Example
To display sFlow configuration and operational status, use the command:
awplus#
Output
Table 1: Example output from the show sflow command
Table 2: Parameters in the output of the show sflow command
C613-50103-01 REV A
show sflow
sFlow Agent Configuration:
sFlow Admin Status ........ Disabled
sFlow Agent Address ....... [not set]
Collector Address ......... 0.0.0.0
Collector UDP Port ........ 6343
Tx Max Datagram Size ...... 1200
sFlow Agent Status:
Polling/sampling/Tx ....... Inactive because:
Output Parameter
sFlow Admin
Status
sFlow Agent
Address
Collector Address
Collector UDP
Port
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
- sFlow is disabled
- Agent Addr is not set
- Collector Addr is 0.0.0.0
- Polling & sampling disabled
on all ports
Description
Whether sFlow agent operation is administratively
enabled.
The sFlow agent IPv4 or IPv6 address for the device. sFlow
is rendered inactive whenever the agent address is not set.
The IPv4 or IPv6 collector address to which sFlow
datagrams are sent. sFlow is rendered inactive whenever
the collector address is set to 0.0.0.0 or 0:0::0.0.
The UDP port on the collector to which sFlow datagrams
are sent.
Default Values
[Disabled]
[not set]
[0.0.0.0]
[6343]
[1400]
2521
Advertisement
Table of Contents
