Length (Ping-Poll Data) - Allied Telesis x310-26FT Command Reference Manual

P -P C
ING OLLING OMMANDS
( - )
LENGTH PING POLL DATA

length (ping-poll data)

Overview This command specifies the number of data bytes to include in the data portion of
the ping packet. This allows you to set the ping packets to a larger size if you find
that larger packet types in your network are not reaching the polled device, while
smaller packets are getting through. This encourages the polling instance to
change the device's status to unreachable when the network is dropping packets
of the size you are interested in.
The no variant of this command resets the data bytes to the default of 32 bytes.
length <4-1500>
Syntax
no length
Default The default is 32.
Mode Ping-Polling Configuration
Examples To specify that ping-poll instance 12 sends ping packet with a data portion of 56
bytes, use the commands:
awplus#
awplus(config)#
awplus(config-ping-poll)#
To reset the number of data bytes in the ping packet to the default of 32 bytes for
ping- poll instance 3, use the commands:
awplus#
awplus(config)#
awplus(config-ping-poll)#
Related ping-poll
Commands
show ping-poll
C613-50103-01 REV A
Parameter Description
<4-1500>
The number of data bytes to include in the data portion of the ping
packet.
configure terminal
ping-poll 12
configure terminal
ping-poll 12
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
length 56
length
2489