Sflow Polling-Interval - Allied Telesis x310-26FT Command Reference Manual

F C
S LOW OMMANDS
-
SFLOW POLLING INTERVAL

sflow polling-interval

Overview This command sets the sFlow® counter polling interval (in seconds) for the
specified ports. A value of 0 disables polling. A counter sample is taken every N
seconds where N is the value set by this command.
The no variant of this command applies the default.
Syntax
no sflow polling-interval
Default The polling-interval is 0 (polling disabled).
Mode Interface Configuration
Example To set the polling interval to 60 seconds for ports 1.0.1 and 1.0.7, use the following
commands:
awplus#
awplus(config)#
awplus(config-if)#
Related show running-config sflow
Commands
show sflow interface
C613-50103-01 REV A
sflow polling-interval {0|<1-16777215>}
Parameter
0
<1-16777215>
configure terminal
interface port1.0.1,port1.0.7
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
Disable polling (the default).
The polling interval in seconds.
sflow polling-interval 60
2516