Ping-Poll - Allied Telesis x310-26FT Command Reference Manual

P -P C
ING OLLING OMMANDS
-
PING POLL

ping-poll

Overview This command enters the ping-poll configuration mode. If a ping-poll exists with
the specified number, then this command enters its configuration mode. If
no-ping poll exists with the specified number, then this command creates a new
ping poll with this ID number.
To configure a ping-poll, create a ping poll using this command, and use the
(ping-polling)
poll. It is not necessary to specify any further commands unless you want to
change a command's default.
The no variant of this command deletes the specified ping poll.
ping-poll <1-100>
Syntax
no ping-poll <1-100>
Mode Global Configuration
Examples To create ping-poll instance 3 and enter ping-poll configuration mode, use the
commands:
awplus#
awplus(config)#
awplus(config-ping-poll)#
To delete ping-poll instance 3, use the commands:
awplus#
awplus(config)#
Related active (ping-polling)
Commands
clear ping-poll
debug ping-poll
description (ping-polling)
ip (ping-polling)
length (ping-poll data)
show ping-poll
source-ip
C613-50103-01 REV A
command to specify the device you want the polling instance to
Parameter Description
<1-100>
A unique ping poll ID number.
configure terminal
ping-poll 3
configure terminal
no ping-poll 3
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ip
2491