Source-Ip - Allied Telesis x310-26FT Command Reference Manual

P -P C
ING OLLING OMMANDS
-
SOURCE IP

source-ip

Overview This command specifies the source IP address to use in ping packets.
By default, the polling instance uses the address of the interface through which it
transmits the ping packets. It uses the device's local interface IP address when it is
set. Otherwise, the IP address of the interface through which it transmits the ping
packets is used.
The no variant of this command resets the source IP in the packets to the device's
local interface IP address.
source-ip {<ip-address>|<ipv6-address>}
Syntax
no source-ip
Mode Ping-Polling Configuration
Examples To configure the ping-polling instance 43 to use the source IP address
192.168.0.1 in ping packets, use the commands:
awplus#
awplus(config)#
awplus(config-ping-poll)#
To configure the ping-polling instance 43 to use the source IPv6 address
2001:db8:: in ping packets, use the commands:
awplus#
awplus(config)#
awplus(config-ping-poll)#
To reset the source IP address to the device's local interface IP address for ping-poll
instance 43, use the commands:
awplus#
awplus(config)#
awplus(config-ping-poll)#
C613-50103-01 REV A
Parameter Description
<ip-address> An IPv4 address in dotted decimal notation A.B.C.D
<ipv6-address> An IPv6 address in hexadecimal notation X:X::X:X
configure terminal
ping-poll 43
configure terminal
ping-poll 43
configure terminal
ping-poll 43
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
source-ip 192.168.0.1
source-ip 2001:db8::
no source-ip
2500