Debug Sflow - Allied Telesis x310-26FT Command Reference Manual

F C
S LOW OMMANDS

DEBUG SFLOW

debug sflow
Overview This command enables sFlow® debug message logging, for sFlow sampling and
polling activity on the specified ports. If no ports are specified, sampling and/or
polling debug messages are enabled for all ports.
The no variant of this command disables sFlow sampling and or polling debug
message logging on the ports selected. If no ports are specified, sampling and/or
polling debug messages are disabled on all ports.
debug sflow [interface <port-list>] [sampling][polling]
Syntax
no debug sflow [interface <port-list>] [sampling][polling]
Default The sFlow sampling and or polling debug is disabled.
Mode Privileged Exec
To enable sFlow debug message logging for polling and sampling on port1.0.1
Examples
and port1.0.7, use the commands:
awplus#
polling
To enable logging and polling of sFlow debug messages for polling and sampling
on all ports, use the command:
awplus#
Related show debugging sflow
Commands
no debug all
C613-50103-01 REV A
Parameter Description
interface
Interface information.
<port-list>
The ports for which sFlow debug is to be enabled. The ports to
display information about. The port list can be:
• a switch port (e.g. port1.0.12)
• a continuous range of ports separated by a hyphen, e.g.
port1.0.1-1.0.24
• a comma-separated list of ports and port ranges, e.g.
port1.0.1,port1.0.1-1.0.24.
sampling
Debug sFlow sampling for the specified port(s).
polling
Debug sFlow polling for the specified port(s).
debug sflow interface port1.0.1,port1.0.7 sampling
debug sflow sampling polling
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
2506