Table of Contents
Advertisement
T
C
RIGGER
OMMANDS
TEST
test
Overview
This command puts the trigger into a diagnostic mode. In this mode the trigger
may activate but when it does it will not run any of the trigger's scripts. A log
message will be generated to indicate when the trigger has been activated.
The no variant of this command takes the trigger out of diagnostic mode, restoring
normal operation. When the trigger activates the scripts associated with the
trigger will be run, as normal.
test
Syntax
no test
Mode
Trigger Configuration
Usage
Configure a trigger first before you use this command to diagnose it. For
information about configuring a trigger, see the
Configuration
Examples
To put trigger 5 into diagnostic mode, where no scripts will be run when the trigger
activates, use the commands:
awplus#
awplus(config)#
awplus(config-trigger)#
To take trigger 205 out of diagnostic mode, restoring normal operation, use the
commands:
awplus#
awplus(config)#
awplus(config-trigger)#
Related
show trigger
Commands
trigger
C613-50103-01 REV A
Guide.
configure terminal
trigger 5
test
configure terminal
trigger 205
no test
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Triggers Feature Overview and
2458
Advertisement
Table of Contents
