Show Debugging Sflow - Allied Telesis x310-26FT Command Reference Manual

F C
S LOW OMMANDS

SHOW DEBUGGING SFLOW

show debugging sflow
Overview This command displays sFlow® debug settings for agent operation, and for
sampling and polling on specific interface ports. If no interface ports are specified,
sampling and polling will be applied to all ports.
Syntax
Mode User Exec and Privileged Exec
Example To display sFlow debug settings on the agent, and for sampling and polling on
ports 1.0.1 to 1.0.9, use the command:
awplus#
Output Figure 61-1: Sample obtained for an sFlow agent
To display sFlow debug settings for all ports, use the command:
awplus#
C613-50103-01 REV A
show debugging sflow [interface <port-list>]
Parameter Description
interface
The interface information.
<port-list>
The ports for which the sFlow debug settings are to be shown.
The ports to display information about. The port list can be:
• a switch port (e.g. port1.1.12)
• a continuous range of ports separated by a hyphen, e.g.
• a comma-separated list of ports and port ranges, e.g.
show debugging sflow interface port1.0.1-1.0.9
awplus# show debugging sflow interface port1.0.1-1.0.9

sFlow Agent Debug:

Sampling
Port Debug
-------------------------------
1.0.1 Enabled
1.0.2 Enabled
1.0.3 -
1.0.4 -
1.0.5 -
1.0.6 -
1.0.7 -
1.0.8 -
1.0.9 -
show debugging sflow
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
port1.0.1-1.0.24
port1.0.1,port1.0.1-1.0.24.
Enabled
Polling
Debug
Enabled
-
-
-
-
Enabled
-
Enabled
Enabled
2518