Decommissioning Of Balancing Device - ABB IRB 6660 - 130/3.1 Product Manual

Articulated robot
Hide thumbs Also See for IRB 6660 - 130/3.1:
Table of Contents

Advertisement

6.3. Decommissioning of balancing device

NOTE!
This section is not applicable to robot variant IRB 6660 - 205/1.9.
General
There is much energy stored in the balancing device. Therefore a special procedure is
required to dismantle it. The coil springs inside the balancing device exert a potentially lethal
force unless dismantled properly.
The device must be dismantled by a decommissioning company.
Required equipment
Equipment
Standard toolkit
Cutting torch
Other tools and procedures may be
required. See references to these
procedures in the step-by-step
instructions below.
DANGER!
Do not under any circumstances, deal with the balancing device in any other way than that
detailed in the product documentation! For example, attempting to open the balancing device
is potentially lethal!
Action on field, decommissioning
The procedure below details the actions to perform on field, when the balancing device is to
be decommissioned.
3HAC028197-001 Revision: A
Action
1. Remove the balancing device from the robot. Detailed in section
2. Send the device to a decommissioning
company.
6 Decommissioning
6.3. Decommissioning of balancing device
Art. no.
Note
-
The content is defined in section
Standard toolkit on page
For opening housing and cutting coils
These procedures include references
to the tools required.
Note
Make sure the decommissioning
company is well informed about the
stored energy built up by high tensioned
compression springs and that the device
contains some grease.
The following procedure contains useful
information about decommissioning.
280.
Removal on page
219.
Continues on next page
271

Advertisement

Table of Contents
loading

This manual is also suitable for:

Irb 6660 - 205/1.9

Table of Contents