Table of Contents
Advertisement
Inspection, dampers
The procedure below details how to inspect the dampers, axes 2-5.
3HAC028197-001 Revision: A
Action
1.
DANGER!
Turn off all electric power, hydraulic and pneumatic
pressure supplies to the robot!
2. Check all dampers for damage, and for cracks or
existing impressions larger than 1 mm.
To inspect the damper axis 4, remove the two covers
on top of the upper arm!
3. Check attachment screws for deformation.
4. If any damage is detected, the damper must be
replaced with a new one!
3 Maintenance
3.3.11. Inspection, damper axes 2-5
Note
Shown in the figure
dampers on page
112.
Art. no. is specified in
equipment on page
Continued
Location of
Required
112.
113
Advertisement
Table of Contents
