Table of Contents
Advertisement
4 Repair
4.6.5. Replacement of motor, axis 6
Continued
Equipment, etc.
Guide pins M8 x 100
Guide pins M8 x 150
Power supply
Grease
Standard toolkit
Calibration Pendulum
toolkit
Other tools and
procedures may be
required. See
references to these
procedures in the step-
by-step instructions
below.
Circuit Diagram
Removal, motor
The procedure below details how to remove the motor, axis 6.
240
Spare part no.
Action
1. Move the robot to a position where the motor in axis
6 is pointed straight up. This position enables the
motor to be replaced without draining the gear oil,
which in turn saves time.
2.
DANGER!
Turn off all electric power, hydraulic and pneumatic
pressure supplies to the robot!
3. Remove the rear motor cover by unscrewing the five
attachment screws.
4. Disconnect all connectors beneath the cover.
5. In order to release the brake, connect the 24 VDC
power supply.
Art. no.
Note
3HAC15520-1
For guiding the motor.
3HAC15520-2
For guiding the motor.
-
24 VDC, 1.5 A
For releasing the brakes.
3HAB3537-1
For lubricating the o-ring.
-
The content is defined in
section
Standard toolkit on
page
280.
3HAC15716-1
Complete kit that also
includes operating manual.
These procedures include
references to the tools
required.
3HAC025744-
See chapter
001
Note
Connect to connector R3.MP6
•
+: pin 2
•
-: pin 5
Continues on next page
3HAC028197-001 Revision: A
Circuit
diagram.
Advertisement
Table of Contents
