Table of Contents
Advertisement
A
31
7
Address A
Byte 0
15
Address A + 4
31
Address A + 8
Note: The SH7750 Series does not support endian conversion for the 64-bit data format.
Therefore, if double-precision floating-point format (64-bit) access is performed in little
endian mode, the upper and lower 32 bits will be reversed.
2.6
Processor States
The SH7750 has five processor states: the reset state, exception-handling state, bus-released state,
program execution state, and power-down state.
Reset State: In this state the CPU is reset. The reset state is entered when the 5(6(7 pin goes
low. The CPU enters the power-on reset state if the 05(6(7 pin is high, and the manual reset
state if the 05(6(7 pin is low. For more information on resets, see section 5, Exceptions.
In the power-on reset state, the internal state of the CPU and the on-chip peripheral module
registers are initialized. In the manual reset state, the internal state of the CPU and registers of on-
chip peripheral modules other than the bus state controller (BSC) are initialized. Since the bus
state controller (BSC) is not initialized in the manual reset state, refreshing operations continue.
Refer to the register configurations in the relevant sections for further details.
Exception-Handling State: This is a transient state during which the CPU's processor state flow
is altered by a reset, general exception, or interrupt exception handling source.
In the case of a reset, the CPU branches to address H'A000 0000 and starts executing the user-
coded exception handling program.
In the case of a general exception or interrupt, the program counter (PC) contents are saved in the
saved program counter (SPC), the status register (SR) contents are saved in the saved status
register (SSR), and the R15 contents are saved in saved general register 15 (SGR). The CPU
branches to the start address of the user-coded exception service routine found from the sum of the
contents of the vector base address and the vector offset. See section 5, Exceptions, for more
information on resets, general exceptions, and interrupts.
Program Execution State: In this state the CPU executes program instructions in sequence.
Rev. 4.0, 04/00, page 22 of 850
A + 1
A + 2
23
15
7
0 7
0 7
0 7
Byte 1 Byte 2 Byte 3
0 15
Word 0
Word 1
Longword
Big endian
Figure 2.5 Data Formats In Memory
A + 3
A + 11
0
31
0
7
0 7
Byte 3
0
15
Word 1
0
31
A + 10 A + 9
A + 8
23
15
7
0 7
0 7
Byte 2 Byte 1 Byte 0
0
15
Word 0
Longword
Little endian
0
0
Address A + 8
0
Address A + 4
0
Address A
Advertisement
Table of Contents
