Configuring RADIUS
Configuring RADIUS
Purpose
To perform the following:
•
Review the RADIUS client/server configuration on the switch.
•
Enable or disable the RADIUS client.
•
Set local and remote login options.
•
Set primary and secondary server parameters, including IP address, timeout period,
authentication realm, and number of user login attempts allowed.
•
Reset RADIUS server settings to default values.
•
Configure a RADIUS accounting server.
•
Configure the interface used for the source IP address of the RADIUS application when
generating RADIUS packets.
•
Configure RADIUS to use IPsec on transactions with specified servers.
•
Configure MS-CHAPv2 support for passwords between the switch and RADIUS server.
Commands
For information about...
show radius
set radius
set radius ipsec
clear radius
clear radius ipsec
show radius accounting
set radius accounting
clear radius accounting
show radius interface
set radius interface
clear radius interface
set radius attribute mgmt password
show radius attribute mgmt password
show radius
Use this command to display the current RADIUS client/server configuration.
Syntax
show radius [status | retries | timeout | server [index | all]]
32-6 Authentication and Authorization Configuration
Refer to page...
32-6
32-8
32-10
32-10
32-11
32-12
32-12
32-13
32-14
32-14
32-15
32-16
32-17