Ip Rip Offset - Enterasys Matrix 2G4072-52 Configuration Manual

13.2.2.5

ip rip offset

Use this command to add or remove an offset to the metric of an incoming or outgoing RIP route.
Adding an offset on an interface is used for the purpose of making an interface a backup.
ip rip offset {in | out} value
Syntax Description
in
out
value
Command Syntax of the "no" Form
The "no" form of this command removes an offset:
no ip rip offset {in | out}
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
The following example shows how to add an offset of 1 to incoming RIP metrics on VLAN 1:
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip rip offset in 1
Applies the offset to incoming metrics.
Applies the offset to outgoing metrics.
Specifies a positive offset to be applied to routes learned via
RIP. Valid values are from 0 to 16. If the value is 0, no action
is taken.
Matrix DFE-Platinum and Diamond Series Configuration Guide
Routing Protocol Configuration Command Set
Configuring RIP
13-9