Show Lacp - Enterasys Matrix 2G4072-52 Configuration Manual

Configuring LACP
Configuring Link Aggregation
4.5.4.1

show lacp

Use this command to display the global LACP enable state, or to display information about one or
more aggregator ports. Each Matrix Series module provides 48 virtual link aggregator ports, which
are designated in the CLI as lag.0.1 through lag.0.48. Once underlying physical ports (i.e.; fe.x.x,
ge.x.x) are associated with an aggregator port, the resulting aggregation will be represented as one
Link Aggregation Group (LAG) with a lag.x.x port designation.
show lacp [state | port-string]
Syntax Description
state
port-string
Command Defaults
•
•
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display information for aggregator port 48
Matrix(rw)->show lacp lag.0.48
Aggregator:
System Identifier:
Table 4-9
4-100 Matrix DFE-Platinum and Diamond Series Configuration Guide
If state is not specified, aggregator information will be displayed for specified
ports.
If port-string is not specified, link aggregation information for all ports will be
displayed.
lag.0.48
System Priority:
Admin Key:
Oper Key:
Attached Ports:
provides an explanation of the command output.
(Optional) Displays the global LACP enable state.
(Optional) Displays LACP information for specific LAG
port(s). Valid port designations are lag.0.1 - 48.
Actor
00:e0:63:9d:b5:87
32768
32768
32768
None.
:
Partner
00:00:00:00:00:00
32768
32768