Chapter 3: Troubleshooting; Checking The Leds; Figure 3-1 Switch Status Leds (08G20G4-24 Shown) - Enterasys 08H20G4-24 Hardware Installation Manual

This chapter contains instructions on troubleshooting the 800-Series as required. This can include:
For information about...

Checking the LEDs

Troubleshooting Checklist
Removing the Switch from a Rack
Checking the LEDs
The following sections define the behavior of the LEDs on the 800-Series chassis models. The LEDs
on all chassis are located in the same location on the front panel.
Refer to
Figure 3-1
Fan LED
1
Redundant Power Supply (PWR) LED
2
CPU LED
3
Electrical Hazard: Only qualified personnel should install or service this unit.
Riesgo Eléctrico: Nada mas personal capacitado debe de instalar o darle servicio a esta unida.
Elektrischer Gefahrenhinweis: Installationen oder Servicearbeiten sollten nur durch
ausgebildetes und qualifiziertes Personal vorgenommen werden.
Figure 3-1 for the location of the LEDs on the chassis.
Switch status LEDs (08G20G4-24 shown)
Troubleshooting
Power (PWR) LED
4
Copper 10/100/1000 Mbps port status LEDs
5
SFP 100/1000 Mbps port status LEDs
6
Enterasys 800-Series Hardware Installation Guide 3-1
3
Refer to page...
3-1
3-6
3-7