Mg-Ana (Analog Mm711) - Avaya G700 Maintenance Manual

6 Avaya MultiVantage Software-Controlled Maintenance:

MG-ANA (ANALOG MM711)

Note:
Table 53. MG-ANA (ANALOG MM711)
MO Name (in Alarm
Log)
MG-ANA
Note: You must consult local records for the location and designation of the equipment
rack where the G700 is mounted.
The MM711 Analog Trunk and Line Media Module provides 8 ports, any of which may be administered as
one of the following:
Table 54. MM711 Analog Trunk and Line Media Module – port administration
Function
Central Office trunk (CO)
CAMA/E911 trunk
Direct Inward Dialing
(DID) trunk
Analog Line
on-or-off premises
The MM 711 Analog Media Module supports eight analog interfaces allowing the connectivity of Loop
Start, Ground Start, Analog DID trunks, and 2-wire analog Outgoing CAMA E911 trunks. As well, the
MM711 Analog Media Module allows connectivity of analog, tip/ring devices such as single line
telephones, modems, or group 3 fax machines. Each port may be configured as either a trunk interface or a
station interface.
Also included is support for caller ID signaling, ring voltage generation for a variety of international
frequencies and cadences and administrable line termination styles.
The MM711 Analog Trunk and Line Media Module does not support Neon Lamp Message Waiting
Indication ( MWI ). No maintenance of the terminal connected to the Neon Analog Line Media Module is
performed.
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
For more information, refer to the MO XXX-BD section of this document.
In addition, refer to the AN-LN-PT MO and to the CO-TRK MO.
For Location
GGGVSPP
Group Type
co
fx
wats
cama
did
n/a
MG-ANA (ANALOG MM711)
Full Name of MO
ANALOG MEDIA
MODULE
Trunk Type LED MWI
loop start
ground start
loop start
wink start
immed start
n/a with/
without MWI
193