Media Module Maintenance; Hot Swap - Avaya G700 Maintenance Manual

1 Maintenance Strategy:

Media Module Maintenance

Media Module maintenance is controlled by MultiVantage maintenance software. Maintenance for each
Media Module is very similar to that for its respective DEFINITY server counterpart.

Hot Swap

The following Media Modules are hot swappable:
• DCP Media Module (MM712)
• Analog Trunk/Telephone Port Board Media Module (MM711)
• E1/T1 Media Module with CSU (MM710)
• VoIP Media Module (MM760)
• BRI Media Module (MM720)
For procedures on adding, removing, or replacing Media Modules, refer to "Inserting Media
Modules" in the "Installation and Upgrades for the Avaya
Avaya TM S8300 Media Server or an Avaya
on page 76.
!
CAUTION:
!
CAUTION:
!
CAUTION:
26
The S8300 Media Server is NOT hot swappable and can reset the entire G700
upon insertion or removal, as well as resetting each G700 that is currently regis-
tered with it. When removing the S8300, initiate a shutdown process by first
depressing the button (for 2 seconds) located next to the fourth GREEN "Ok-to-
Remove" LED (specific to the S8300). This LED will first blink; then go steady.
Once steady, this GREEN LED indicates that the disk drive has been parked
properly and is ready to be removed. See "Replacing the S8300 Media Server"
on page 73.
If you remove the S8300 before the disk is parked, you may corrupt important
data. See "Replacing the S8300 Media Server" on page 73.
The Avaya Expansion Modules and Cascade Modules — are NOT hot-swappa-
ble. They are service-disrupting and can reset the entire G700 upon insertion or
removal. Power down the system prior to any insertion or removal of Avaya
Expansion and Cascade modules.
TM G700 Media Gateway controlled by an
TM S8700 Media Server" and "Media Module Replacement"
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
Media Module Maintenance