Set Mgp Icc Monitoring; Set Mgp Reset Times - Avaya G700 Maintenance Manual

B CLI Reference for the G700 Media Gateway Processor: CLI Command Reference Pages
command is used to designate which of these to use upon bootup.
Parameters:
Sample Display
MG-001-3(configure)# set mgp bootimage a
Administration Commands

set mgp icc monitoring

Privilege:
Description: set mgp icc-monitoring { enable | disable }
If an S8300/LSP is expected to be present in slot 1 of the MG, the MGPcan send
a trap if the S8300/LSP heartbeat is not present. This command sets whether or
not the S8300/LSP will be monitored by the MGP.
Parameters:
Sample Display
MG-001-3(configure)# set mgp icc-monitoring enable
Administration Commands

set mgp reset times

Privilege:
Description: set mgp reset-times { [[total-search | primary-search] <min-
utes>] | [transition-point <value>] }
The MGP has a set of 3 timers that are used as part of the recovery process if
the MG and MGC loose their connectivity. They are configuration dependant.
Parameters:
mary-search (1-60, [15]) minutes;
334
"a" or "b" refer to the flash memory units in the MG.
| Processor
Configure
None
| Processor
Configure
<value> is in minutes. total-search (1-60, [30]) minutes; pri-
| CC | QOS | Network | Maintenance
| CC | QOS | Network | Maintenance
transition-point(aka, "entry number") (1-
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
| E1/T1 CSU
| E1/T1 CSU