Port Audit Update Test (#36) - Avaya G700 Maintenance Manual

6 Avaya MultiVantage Software-Controlled Maintenance:

Port Audit Update Test (#36)

This test sends updates of the DID port translation for all ports on the Media Module that have been
translated. The update is non-disruptive and guards against possible corruption of translation data
contained on the Media Module. No response message is expected from the Media Module once it
receives translation updates. The port translation data includes:
• Wink or immediate start trunk
• Dial tone or rotary dialing trunk
• Rotary dialing inter-digit timing
• Network balance R/RC
• Disconnect timing
Table 16. TEST #36 Port Audit Update Test
Error
Code
1006
2100
144
Test Description/ Recommendation
Result
ABORT Could not allocate the necessary system resources to run this test.
Retry the command at 1-minute intervals a maximum of 5 times.
ABORT The port is out of service, perhaps busied out.
Use display port GGGVSpp to determine the trunk
group/member number of the port. Use status trunk to determine
the service state of the port. If the port is out of service, wait until
the port is in service and idle before testing.
If the port status is in service and idle, then retry the command at
1-minute intervals a maximum of 5 times.
ABORT Could not allocate the necessary system resources to run the test.
Retry the command at 1-minute intervals a maximum of 5 times.
FAIL Internal system error
Retry the command at 1-minute intervals a maximum of 5 times.
PASS This test passed. Translation information was successfully updated
on the Media Module.
If signaling troubles are reported (Error Types 1, 257, or 513),
verify translation for this port.
Refer problem to the CO .
DID-TRK (Direct Inward Dial Trunk)
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002