Avaya G700 Maintenance Manual page 233

6 Avaya MultiVantage Software-Controlled Maintenance:
Table 71. TEST #144 Slip Alarm Inquiry Test
Error
Code
2000
2100
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
Test Description/ Recommendation
Result
ABORT Internal system error
Retry the command at 1-minute intervals a maximum of 5 times.
ABORT Response to the test was not received within the allowable time
period. This may be due to hyperactivity. Error Type 1538 in the error
log indicates hyperactivity. The hyperactive Media Module is out of
service and one or more of the following symptoms may be exhibited.
The DS1-MM tests (such as Test #138 and Test #139) are aborting
with error code 2000.
The tests run on the ports of this Media Module are returning a no
board result.
A busyout or a release command has no affect on the test results.
A list config command shows that the Media Module and the ports
are properly installed.
When hyperactivity occurs, the Media Module is isolated from the
system, and all of the trunks for this Media Module are placed into the
out of service state. The system will try to restore the Media Module
within 15 minutes. When no faults are detected for 15 minutes, the
DS1-MM interface Media Module is restored to normal operation. All
of the trunks for the DS1-MM interface Media Module are then
returned to the in service state. Hyperactivity is often caused by the
associated facility. In such a case, faults (such as slips, misframes, or
blue alarms) would be entered in the error log. In addition, many
hardware errors would be logged against the associated trunk
circuits. If the facility is OK and the error occurs again after 15
minutes, replace the Media Module.
ABORT Could not allocate the necessary system resources to run this test.
Retry the command at 1-minute intervals for a maximum of 5 times.
MG-DS1 (DS1 Interface Media Module)
1 of 3
233