B CLI Reference for the G700 Media Gateway Processor: Media Gateway - Processor CLI Commands
set system location
set system name
show hostname
show mg list_config
show mm
show post
show sync timing
show system
show timeout
tech
terminal length
terminal width
tree
Media Gateway - Processor CLI Commands
Processor
The following set of commands is used when working on the G700 Media Gateway processor.
set mgp bootimage
set mgp icc monitoring
set mgp reset times
show restart log
show mgp icc-
monitoring
show mgp recovery
show mgp bootimage
310
Sets the name of the site location
Sets the system name
Shows the current prompt string
Shows installed MG equipment
Shows MG Media Module info
Shows Power On Self Test results
Shows state of clocking sources
Shows system ID information
Shows the auto-logout time
Changes to a mode for access to tech level commands
Sets the number of terminal lines
Sets or displays the number of characters per line
Shows available commands
Specifies boot image source
Enables/Disables heartbeat monitoring of an ICC/LSP
Sets the MGP recovery process timers
Retrieves raw restart log entries
Displays the current state of the ICC monitoring watchdog.
Shows the MGP monitoring and recovery setup
Identifies memory bank used for mgp boot
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002