Misframe Alarm Inquiry Test (#145) - Avaya G700 Maintenance Manual

Gateway/ server or an
Hide thumbs Also See for G700:
Table of Contents

Advertisement

6 Avaya MultiVantage Software-Controlled Maintenance:
Table 71. TEST #144 Slip Alarm Inquiry Test Continued
Error
Code
Any

Misframe Alarm Inquiry Test (#145)

Misframe Alarm indicates that framing bits observed on a DS1-MM Interface Media Module are in
error. The Misframe Alarm Inquiry Test queries the total number of misframes that have occurred on
a DS1 Interface Media Module since the last inquiry.
When the DS1 Interface Media Module detects a misframe error, it increments its misframe counter
by one. If the counter reaches a specified threshold (i.e., 17), a MISFRAME-COUNT message is
automatically sent to the switch maintenance software. After the maintenance software receives the
MISFRAME-COUNT message, the Misframe Alarm Inquiry Test is initiated to collect the misframe
counts from the DS1-MM Interface Media Module.
A Minor alarm against the DS1-MM Interface Media Module is raised, but all trunks or ports of the
DS1-MM Interface Media Module remain in the in-service state.
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
Test
Description/ Recommendation
Result
NO
The test could not relate the internal ID to the port (no board). This
BOARD
could be due to incorrect translations, no board is inserted, an
incorrect board is inserted, or an insane board is inserted.
Ensure that the board translations are correct. Execute the add ds1
GGGVS command to administer the DS1-MM interface if it is not
already administered.
If the board was already administered correctly, check the error log to
determine whether the board is hyperactive. If this is the case, the
board is shut down. Reseating the board will re-initialize the board.
If the board was found to be correctly inserted in step 1, then issue
the busyout board command.
Issue the reset board command.
Issue the release busy board command.
Issue the test board long command.
This should re-establish the linkage between the internal ID and the
port.
MG-DS1 (DS1 Interface Media Module)
3 of 3
235

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

S8700S8300

Table of Contents