Error Log Entries And Test To Clear Values - Avaya G700 Maintenance Manual

6 Avaya MultiVantage Software-Controlled Maintenance:

Error Log Entries and Test to Clear Values

Table 51. Analog Line Error Log Entries
Error
Type
0*
1(a)
15(b)
18
130(c)
257(d)
513(e)
769
*Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to
the appropriate test description and follow the recommended procedures.
**Minor alarms on this MO may be downgraded to Warning alarms based on the values
used in the set options command.
Notes:
• (a) Error Type 1 : these are in-line errors and can only be resolved over time.
- Aux Data 40960 indicates that too many simultaneous incoming ringing attempts were made
on this board. Only 4 ports on a board may ring simultaneously. A 5th incoming call will
cause an inline error from the board.
- Aux Data 40975 indicates that the terminal equipment was on-hook when ring-tip was
detected during ringing. This usually indicates a failure in the terminal equipment or the type
of terminal has a low ringer impedance.
• Call the terminal equipment and verify that the terminal rings.
• If the terminal does not ring, then replace it.
• Otherwise, issue the test port GGGVSpp command, and follow the procedure for
Test #48.
- 40977 indicates that no terminal equipment was connected when ringing was attempted.
• Run the short test via the test port GGGVSpp command, and follow the procedure
for the results of Test #48.
106
Aux Associated
Data Test
0 Any
40960 none
40975
40977
Any Audits and
Updates
Test (#36)
0 busy station
extension
None
40973 none
Station
Present Test
(#48)
Battery Feed
Test (#35)
AN-LN-PT (Analog Line Port)
Alarm On/Off
Level Board
Any Any
WRN ON
WRN ON
WRN OFF
MIN/ ON
WRN**
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
Test to Clear Value
test port GGGVSpp sh r 1
release station extension
test port GGGVSpp sh
test port GGGVSpp sh r 2
test port GGGVSpp sh r 2