B CLI Reference for the G700 Media Gateway Processor: CLI Command Reference Pages
or the Media Modules
Parameters:
address of the source host.
Sample Display
Administration Commands
set snmp trap
Privilege:Configure
Description: set snmp
[{all|power|temp|app|module|config|voice|operations}]
Sets the IP address the SNMP trap receiver which will be receiving the traps
from this Media Gateway and what group's traps will be sent to the specified
receiver. If no keywords follow the IP address entry then 'all' traps will be
enabled for the specified receiver. If enable or disable' are used without a
trap designation keyword then all traps' is assumed. Up to 10 trap receivers
can be configured.
Parameters:
ignated trap(s).
Sample Display
MG-001-3(configure)# set snmp trap 132.236.73.3 enable
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
<filename> is the name of the origin file, <ipaddress> is the IP
|
Processor
trap <IP Address> {enable|disable}
The IP address of the trap receiver which will receive the des-
|
CC
|
QOS
|
Network
|
Maintenance
|
E1/T1 CSU
355