B CLI Reference for the G700 Media Gateway Processor: CLI Command Reference Pages
net port (23).
Parameters:
Sample Display
MG-001-3> session mgc
Administration Commands
set interface
Privilege:Configure
Description: set interface {mgp <vlan> <ipaddress> <netmask> |
voip <voipid> <ipaddress> }
Permits the setting of the local static IP addresses for the Media Gateway
Processor and VoIP engines. The VoIP Engines will inherit the netmask defined
by the 'set interface mgp' command
Parameters:
v0-v4 where v0 represents the VoIP engine on the motherboard
the IP address of the interface, and 'netmask' is the IP netmask.
Sample Display
MG-001-3(configure)# set interface mgp 2 132.236.73.23 255.255.255.0
MG-001-3(configure)# set interface voip v2 123.23.44.21
Administration Commands
set ip route
Privilege:
Description: set ip route
Use the set ip route command to add IP addresses to the IP routing
table. You can configure from one to ten (10) default gateways. (Same as for
a Cajun P330 stack.)
Parameters:
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
None
|
Processor
'vlan' is the VLAN number(default=0), 'voipID' is in the range
|
Processor
Privileged
<destination> <mask><gateway>
ipaddress is the IP address, ipgateway is the default gateway.
|
CC
|
QOS
|
Network
|
Maintenance
|
CC
|
QOS
|
Network
|
Maintenance
|
E1/T1 CSU
'ipaddress' is
|
E1/T1 CSU
347